gainvova.blogg.se - Two point scaffold platform width

#TWO POINT SCAFFOLD PLATFORM WIDTH HOW TO#
#TWO POINT SCAFFOLD PLATFORM WIDTH INSTALL#
#TWO POINT SCAFFOLD PLATFORM WIDTH CRACK#

Soil must be compacted and even, and gravel or stone will need to be laid on soft soil or muddy surfaces. Location hazards and safe surfacesīefore erecting a scaffold, check the location for possible hazards like sloping or uneven surfaces, overhead wires, or any other obstructions. Rolling scaffolds, for example, are best suited for jobs of shorter duration and are commonly used for electrical and mechanical work whereas a standard frame scaffold is typically used for longer-term work and heavier loads, and is designed for pedestrians to walk under. It is important to take the specifics of a job site and the nature of the task into consideration before selecting a scaffolding system. There are varying types of scaffolds that are better suited to different work sites and tasks. How do we avoid falls and injuries related to these hazards and improper practices? Let’s take a look at the basics of scaffolding safety and some best practices to observe. If the scaffolding has not been secured properly, this practice also poses a risk to other workers on the platform. Climbing on scaffoldingĬlimbing up and down a scaffolding platform rather than using appropriate equipment like ladders poses another serious risk and has resulted in many falls and injuries. Another common problem is when working material overhangs the scaffold platform and causes the platform to tip and slide.

#TWO POINT SCAFFOLD PLATFORM WIDTH CRACK#

Placing excessive weight on a working platform can cause planks to crack or break. Moving a rolling scaffold while workers are still on the platform can be a very dangerous practice and can cause workers to fall or slip, especially if the working platforms are already insufficient and/or if any of the planks are loose or loaded down too heavily. If scaffold planks are unsecured, overloaded or in bad condition, they can break or slide which causes many falls and injuries. Scaffold electrical hazards include failing to observe safe distances from electrical lines, especially when hoisting scaffolding on a jobsite. Overhead electrical wiresĬontact with electrical wires puts workers in serious danger. Many falls from scaffolds are from platforms of less than 10 feet high, so a guardrail should be considered an important control measure. The use of guardrails is recommended for any platform higher than 5 feet, but this precaution is often not observed which has resulted in falls and serious injuries.

#TWO POINT SCAFFOLD PLATFORM WIDTH INSTALL#

When erecting scaffolding, a common hazard is not providing an appropriate platform for the worker as they are installing the next lift.Īlso, failure to install tie-ins may result in the scaffolding swaying enough to topple someone off their working platform, especially when the platform is not sufficient.Īccidents are frequently reported in situations where the worker was only working from a platform of one or two planks.

Overhead electrical wires and risk of electrocution.

Improper safety measures when raising and dismantling scaffolding.

Here’s a list of common work at heights hazards: While there are different types of scaffolds, there are a number of risks and hazards common to all, as well as corresponding safety measures you can take to mitigate these hazards.

#TWO POINT SCAFFOLD PLATFORM WIDTH HOW TO#

While convenient to use, scaffolds can pose serious risks if proper precautions and working at heights control measures aren’t observed.Ĭonsidering that scaffold hazards cause serious injuries and even fatalities every year, it is important to get a thorough grasp on how to avoid danger and have an appropriate set of scaffolding safety regulations. It’s estimated that over half of all scaffold accidents in Ontario every year are falls.